Chapter 6: BIOS
111
keep all system event logs after each system reboot. The options are
No,
Yes, On next reset,
and Yes, On every reset.
When SEL is Full
This feature allows the user to determine what the BIOS should do when the system event
log is full. Select Erase Immediately to erase all events in the log when the system event log
is full. The options are
Do Nothing
and Erase Immediately.
Custom EFI Logging Options
Log EFI Status Codes
Select EFI (Extensible Firmware Interface) Status Codes to log EFI status codes. Select Error
Codes to log EFI error codes. Select Progress Code to log the EFI progress code. Select
both to log both EFI error codes and progress codes. The options are Disabled, Both,
Error
code
and Progress code.
Note
: After making changes on a setting, be sure to reboot the system for the changes to
take effect.
BMC Network Configuration
The following items will be displayed:
•
IPMI LAN Selection: This feature displays the IPMI LAN setting. The default setting is
Failover
.
•
IPMI Network Link Status: This item displays the IPMI Network Link status. The default
setting is
Dedicated LAN
.
•
Current Configuration Address Source: This feature displays the source of the current IPMI
LAN address. The default setting is
DHCP (Dynamic Host Configuration Protocol)
.
•
Station IP Address: This feature displays the Station IP address for this computer. This
should be in decimal and in dotted quad form (i.e., 192.168.10.253).
•
Subnet Mask: This feature displays the sub-network that this computer belongs to. The
value of each three-digit number separated by dots should not exceed 255.
•
Station MAC Address: This feature displays the Station MAC address for this computer.
Mac addresses are 6 two-digit hexadecimal numbers.
•
Gateway IP Address: This feature displays the Gateway IP address for this computer. This
should be in decimal and in dotted quad form (i.e., 192.168.10.253).
•
VLAN: Select Enabled to enable IPMI VLAN support. The options are
Enabled
and Dis-
abled.
Содержание SuperServer 8049U-E1CR4T
