Supermicro SUPERSERVER 6018R-TD, Руководство пользователя

Страница: 13 / 77

Chapter 2: Server Installation
2-7 2-6
S
UPER
S
ERVER 6018R-TD User's Manual
Installing the Outer Rails to the Rack
1. Attach the longer section of the outer rail to the outside of the shorter section
of the outer rail. You must align the pins with the slides. Both ends of the
outer rail must face the same direction in order to be secured to the rack.
2. Adjust both sections of the outer rail to the proper length so that the rail fits
snugly within the rack.
3. Secure the longer section of the outer rail to the of the rack with two M5
screws and the shorter section to the rear side of the rack with two M5
screws.
4. Repeat steps 1-4 for the remaining outer rail.
SCALE 0.500
Secure to the
Front of the Rack
Secure to the
Rear of the Rack
Figure 2-3. Assembling the Outer Rails
Attach the Two Sections of the
Outer Rail Together
Figure 2-4. Installing the Outer Rails to the Server Rack
SCALE 0.380
1
2
1
3
1
3
Slide rail mounted equipment is not to be used as a shelf or a work space.
Stability hazard. The rack stabilizing mechanism must be in place, or the
rack must be bolted to the floor before you slide the unit out for servicing.
Failure to stabilize the rack can cause the rack to tip over.
Warning: When initially installing the server to a rack, test that the rail
locking tabs engage to prevent the server from being overextended. Have
a rack lift in place as a precaution in case the test fails.
Note:
Figures are for illustrative purposes only. Servers should always be installed
into racks starting at the bottom.