Supermicro SUPERSERVER 6018R-TD, Руководство пользователя

Страница: 14 / 77

Chapter 2: Server Installation
2-9 2-8
S
UPER
S
ERVER 6018R-TD User's Manual
Figure 2-5. Installing the Rack Rails
Installing the Chassis into a Rack
1. Confirm that chassis includes the inner rails (A) and rail extensions (B). Also,
confirm that the outer rails (C) are installed on the rack.
2. Line chassis rails (A and B) with the front of the rack rails (C).
3. Slide the chassis rails into the rack rails, keeping the pressure even on both
sides (you may have to depress the locking tabs when inserting). When
pushed completely into the rack, you should hear the locking tabs "click" into
the locked position.
4. (Optional) Insert and tighten the thumbscrews on the front of the server
1
A
1
B
1
C
Figure 2-6. Installing the Server into a Telco Rack
Installing the Chassis into a Telco rack
To install the chassis into a Telco type rack, use two L-shaped brackets on either
side of the chassis (four total). First, determine how far follow the server will extend
out the front of the rack. Larger chassis should be positioned to balance the weight
between front and back. If a bezel is included on your server, remove it. Then at-
tach the two front brackets to each side of the chassis, then the two rear brackets
positioned with just enough space to accommodate the width of the telco rack.
Finish by sliding the chassis into the rack and tightening the brackets to the rack.
Note: Figures are for illustrative purposes only. Servers should always be installed
into racks starting at the bottom.
Note: Figures are for illustrative purposes only. Servers should always be installed
into racks starting at the bottom.