Supermicro SUPERSERVER 6018R-TD, Руководство пользователя

Страница: 32 / 77

Chapter 5: Advanced Serverboard Setup
5-5 5-4
S
UPER
S
ERVER 6018R-TD User's Manual
Installing a Passive CPU Heatsink
1. Do not apply any thermal grease to the heatsink or the CPU die - the required
amount has already been applied.
2. Place the heatsink on top of the CPU so that the four mounting holes are
aligned with those on the serverboard and the heatsink bracket underneath.
3. Screw in two diagonal screws (i.e., the #1 and the #2 screws) until just snug
(do not over-tighten the screws to avoid possible damage to the CPU.)
4. Add the two remaining screws then fully tighten all four screws.
Removing the Heatsink
Warning: We do not recommend removing the CPU or the heatsink. However, if you
do need to remove it, please follow the instructions below to prevent damage to the
CPU or other components.
1. Unscrew the heatsink screws from the serverboard in the sequence shown
below.
2. Gently wriggle the heatsink to loosen it from the CPU (do not use excessive
force). Once the heatsink is loose, remove it from the CPU.
3. Clean the surface of the CPU and the heatsink, removing the used thermal
grease. Reapply the proper amount of thermal grease on the surface before
re-installing.
Figure 5-1. Installing the Heatsink
Screw #1
Screw #2
Screw #3
Screw #4
8. Make sure the locking mechanism
on the "Close 1st" lever catches
the lip of the load plate. Close and
lock the "Close 1st" lever.
Push down and lock the
lever labeled "Open 1st"
OPEN 1s
t
OPEN 1s
t
Push down and lock the
lever labeled "Close 1st".
9. Close and lock the "Open 1st"
lever.
Engage the lip of
the load plate and
locking portion of
the lever."
7. With the "Close 1st" lever fully
retracted, gently close the load
plate.
Gently close
the load plate.