Supermicro SUPERSERVER 6010H, Руководство пользователя

Страница: 41 / 110

Chapter 5: Advanced Motherboard Setup
5-7
5-6 Installing Memory
1. Memory support:
The supports 128/256/512 MB and 1 GB registered ECC SDRAM
DIMMs. PC133 and PC100 memory are both supported at their respective
speeds. However, the memory bus is synchronized to the front side bus
speed meaning you cannot use PC100 with a 133 MHz FSB and using
PC133 with a 100 MHz FSB will result in 100 MHz memory operation.
2. Interleaved memory:
The uses an interleaved memory scheme to improve perfor-
mance. This requires that you install two modules at a time,
meaning you must populate either both Bank0 slots or all four
DIMM slots. In addition, both DIMMs installed in the same bank
number (i.e. Bank0) must be the same brand, type, size and speed.
3. Installing memory modules:
Insert each DIMM module vertically into its slot. Pay attention to the two
notches along the bottom of the module to prevent inserting the DIMM
module incorrectly. Gently press down on the DIMM module until it snaps
into place in the slot (see Figure 5-4).
!
CAUTION! Exercise extreme care when install-
ing or removing DIMM modules to prevent any
possible damage. The MEC must be populated
in the manner described in Step 2 below.
To Install: Insert module vertically and press down until it snaps into
place. Pay attention to the bottom notches. To Remove:
Use your thumbs to gently push each release tab outward to free the
DIMM from the slot.
Note: Notches
should align
with the
receptive points
on the slot
D I M M S l o t
DIMM
Notches Notches
R e l e a s e
T a b
R e l e a s e
T a b
Figure 5-4. Side View of DIMM Installation into Slot