Supermicro SuperBlade SBM-GEM-X2C+, Руководство пользователя

Страница: 79 / 404

4-9
Chapter 4: InfiniBand Modules
Installing the Module
1. Remove the dummy cover from the bay you want to place the module in.
2. Place the module's release handle in the open position.
3. Slide the module into the module bay until it stops.
4. Push the release handle to the closed position.
After the module has been installed and the handle locked, it will power on after a short
delay and a POST test will run to verify it is working properly.
Removing the Module
1. Pull out the release handle to the open position.
2. Pull the module out of the bay.
3. Replace immediately with another module or with a dummy module cover to
maintain airflow integrity.
Installing/Removing the InfiniBand Pass-Through Module
Before installing the InfiniBand pass-through module make sure the cover to the module
has been installed before proceeding. Refer to the anti-static precautions described in
Chapter 2 .
The InifiniBand pass-through module must be installed into a triple-wide bay. For
instructions on how to create a triple-wide bay, see
Appendix C .
Assuming that you have already created a triple-wide bay out of three single-wide bays,
continue with the steps below.
Installing the Module
1. Remove the dummy cover from the bay you want to place the module in.
2. Place the module's release handle in the open position.
3. Slide the module into the module bay until it stops.
4. Push the release handle to the closed position.
Removing the Module
1. Pull out the release handle to the open position.
2. Pull the module out of the bay.
3. Replace immediately with another module or with a dummy module cover to
maintain airflow integrity.
NOTE: The 10GbE Pass-through module (SBM-XEM-002/M) also requires the
same double-wide bay as the InfiniBand switch module and may be installed
instead of the InfiniBand switch module in your blade enclosure system. Use
the same instructions below for installing either the pass-through module or the
InfiniBand switch module.