Supermicro SuperBlade SBM-GEM-X2C+, Руководство пользователя

Страница: 195 / 404

7-67
Chapter 7: Layer 2/3 Ethernet Switch Firmware
Clicking the B
ASIC
S
ETTINGS
tab brings up the P
ORT
B
ASIC
S
ETTINGS
page ( Figure 7-56 ),
which allows you to configure port status and mode information. This page also helps
configuring priority and MTU. The parameters for this page are shown in
Table 7-38 .
Table 7-38. Port Basic Settings Page Parameters
Parameter Description
Port This displays the port number.
Link status
This column shows the physical link status as an UP or Down arrow. A
green up arrow indicates that the status of the port is up, while the red
down arrow indicates that the status of the port is down.
Admin State
This parameter allows you to administratively configure the admin state as
Up or Down .
Default User Priority This parameter allows you to set the priority from 0 to 7 .
Switch Port
By default all ports are switch ports for layer 2 switching. To configure a
port as a layer 3 routed port, choose
No .
Switch Port Mode Use this control allows to set the access mode as either Trunk or Hybrid .
MTU
This sets the MTU value. The Minimum is 90 and Maximum is 16338 . A
port must be administrativly down in order to change the MTU. Jumbo
frames of up to 9216 bytes are supported on 1G links. Jumbo frames of up
to 16338 bytes are supported on 10G links.
Link Up/Down Trap
This parameter enables or disables SNMP trap generation for port up and
down events.