Supermicro SuperBlade SBI-7125W-S6, Руководство пользователя

Страница: 89 / 94

B-1
Appendix B
iSCSI Setup Procedure
This appendix covers the iSCSI setup procedure for Supermicro blade systems. If you
do not wish to employ this optional interface for your blades, then skip this procedure in
your blade setup.
To implement iSCSI use in Supermicro blade systems, use the procedure below:
1. On boot-up press C
TRL
-D to go to the
I
SCSI P
ORT
S
ELECTION
screen.
2. Set one port to Primary and press <E
NTER
>.
3. Select the
I
SCSI B
OOT
C
ONFIGURATION
option.
4. For D
YNAMIC
IP C
ONFIGURATION
(DHCP) enter information for the following settings:
• Initiator Name
• Initiation IP
• Subnet Mask
• Gateway
• VLAN ID
5. For U
SE
DHCP
FOR I
SCSI T
ARGET
I
NFORMATION
enter information for the following
settings, and then select OK to continue:
• Target Name
• Target IP
• Target Port
• Boot LUN
6. Select S
AVE
C
HANGES AND
E
XIT
on the setup screen.
7. Put the Windows Installation CD into the CD-ROM drive. In Windows press F6 to
load the Intel® iSCSI Setup driver from the disc.
a. If you installed Windows 2003 32-bit SP1 or SP1 R2 then install the Microsoft
Hotfix for Windows Server , KB902113 NDIS QFE . Windows 2003 SP2 contains
the QFE.
b. To Install Windows 2003 x64 you must first create an operating system installa-
tion media including a
Hot Fix referenced from KB article #934848 at:
http://support.microsoft.com/kb/934848/en-us
NOTE: iSCSI installation requires two (2) network switch/pass-thru modules to
implement.