NOTE: DIAGRAMS & ILLUSTRATION ARE NOT TO SCALE.
11
A
B
FRAMING SPECIFICATIONS
Figure 7
Hood Kit Installation
The firebox canopy (hood) shall not be modified or replaced with
a canopy that may be provided with the unvented decorative
room heater.
NOTE: A hood comes standard and is required. The factory-supplied
hood must be installed on the firebox for safe operation in all installa-
tions. See
Figure 11
.
These hood kits are design to be fitted to the face of the appliance directly
above the firebox opening. In addition to providing an aesthetically pleasing
appearance to your appliance, the hood reduces heat effects to decora-
tive mantels and finish materials located directly above the fireplace and
reduces the Mantel / Trim clearances (see
Figure 4
on
Page 7
).
Please read this entire manual and understood thoroughly before proceed-
ing with the installation of these kits.
Step 1.
Using a 5/16" nut driver or socket, remove the screen and rod
assemblies as shown in
Figure 10.
Step 2.
Align the hood with the holes in the side frames as shown in
Figure 11
. Install three screws as shown in
Figure 11
. Make
sure hood is level and secure.
Step 3.
Reinstall screen and rod assemblies (see
Figure 10
).
Framing Dimensions
Opening
VRT3132WS
VRT3132F
VRT3136WS
VRT3136F
VRT3142WS
VRT3142F
A
38-1/4 (972)
42-1/4 (1073)
48-1/4 (1226)
B
40-1/4 (1022)
40-1/4 (1022)
40-1/4 (1022)
C
19-5/8 (499)
23-5/8 (600)
29-5/8 (753)
D
10-1/4 (260)
12-1/4 (311)
15-1/4 (387)
E
59-3/4 (1518)
63-3/4 (1619)
69-3/4 (1772)
F
29-7/8 (759)
31-7/8 (810)
34-7/8 (886)
G *
20-1/2 (521)
20-1/2 (521)
20-1/2 (521)
H
42-1/4 (1073)
45 (1143)
49-3/8 (1254)
Table 1 - This Table corresponds to Figures 7, 8 and 9
A
C
D
H
F
G
E
Rough Framing Face
(Unfinished Shown)
Back Wall Of Chase/Enclosure
Including Finishing Materials If Any
Back Wall Of Chase/Enclosure
Including Finishing Materials If Any
Rough Framing Face
(Unfinished Shown)
Corner Installation
A
C
G
Parallel Installation
Figure 8
Figure 9
This Figure corresponds to Table 1
This Figure corresponds
to Table 1
This Figure corresponds
to Table 1
Header
Figure 10
Removing Screens and Rods:
Remove screws (see dotted
lines). Pull out rods from
locating holes on side of firebox
opening.
Reinstalling Screens and Rods:
Insert rods into corresponding
locating holes on sides of firebox
opening, then reinstall screws
as shown.
WARNING:
• Do not fill spaces around
the firebox with insulation
or other materials.
• Do not notch framing or
alter the spacers on the
appliance.
* Back wall of chase/enclosure including finishing materials, if any.
