SWTL4510 Operation Manual
66
2)
Clean the gasket surface of filter head by
cloth.
3)
Discard the O-ring.
4)
Install a new O-ring.
5)
Fill the new filter with clean fuel, and lubricate the O-ring seal with clean
lubricating engine oil.
6)
Install the new filter.
•
Make sure you use the filter recommended in this manual.
•
Do not proceed changing the fuel filter just after stopping the engine, since the
engine body is still hot.
•
Oil filters are considered special waste. It has to be collected following the current
environment regulation.
•
Use proper tools only in order to avoid damaging the filter.
6.5.4.6 CHECKING THE NUT TORQUE OF THE HYDARULIC MOTOR AND THE
HUB HOLDING TO THE CHASSIS
•
For the operator’s security check the screw that hold the hydraulic motor to the chassis.
Take as reference the following driving torque given in the following table:
Driving Torque for Hydraulic Motor
160 Nm
•
Check the driving torque that holds the hub-holding.
Take as reference the following driving torque given in the following table:
Driving Torque for Hub-Holding
160 Nm
6.5.5 EVERY 500 HOURS OF OPERATION
6.5.5.1 CLAEN THE FUEL-WATER SEPARATOR
Proceed as follow for cleaning the fuel-water separator:
：
1) Turn the handle to cut off the fuel flow into the separator.
2) Loosen the fuel-water separator by a ring (See picture below).
