SWTL4510 Operation Manual
64
6.5.2.5CHECKING THE WHEEL NUT DRIVING TORQUE
•
Check the wheel nut torque every 50 hours. Refer to the following table.
Driving Torque for Wheels Assembly
Front Wheels
Rear Wheels
150 Nm
150 Nm
6.5.3 EVERY 100 HOURS OF OPERATION
6.5.3.1 CLEANING THE TERMINALS OF THE BATTERY
•
Keep the battery terminals clean is very important, since it ensure a good electricity
flow.
。
•
Clean the battery with gloves. Never clean the terminals directly with your hands.
6.5.3.2 CLEANING THE OIL TANK’S BREATHER
•
Keep the tank breather clean is very important, since it ensures a pressure release inside
the oil tank.
6.5.3.3 CHECKING THE CYLINDER RODS
•
Make sure the cylinder rods are not corroded or damaged. It could reduce the machine’s
efficiency.
6.5.3.4 GREASING ALL OF PINS
•
Grease the pins specified in the item 5.8.
6.5.4 VERY 250 HOURS OF OPERATION
6.5.4.1 CHECKING THE FAN BELT
•
Check the engine manual
6.5.4.2 CLEANING THE RADIATOR
•
Use jet of compressed air or low-pressure water for cleaning the radiator.
•
If necessary use products available in the market specially prepared for cleaning
radiators.
•
Never use oily products, since it facilitate the adhesion of dust and reduces the
efficiency of the radiator.
6.5.4.3 CHANGING THE ENGINE OIL
•
Proceed as follow to change the engine oil: refer to the ENGINE OPERATION AND
MAINTENANCE MANUAL before you doing change the engine oil.
1)
Put a suitable container under the machine so that the oil can be drained
into it.
2)
Remove the draining oil screw so that the oil flows into the container.
3)
During the oil is flowing remove the engine refilling cap, in order easy
the flow.
4)
Check and clean the engine oil drain plug treads and sealing surface,
install the drain plug.
5)
Refill with the recommended engine oil given in this manual.
6)
Fill the engine oil till the oil level to the H mark on the dipstick.
