SUNWARD SWE50B, Руководство по эксплуатации и техническому обслуживанию

Страница: 43 / 197

36
1. When battery is used or charged, mixed gas which is
made up of oxygen and hydrogen gas will be
discharged from exhaust hole.Avoid flame or spark close
to battery. Electricize battery at the well-ventilated area.
Place the machine on dry & hard ground, not on steel
plate, otherwise it may cause spark accidently. Never
connect anode and cathode directly, otherwise it will
cause short circuit.(As figure 3.3.12)
2. When start engine, the operator must sit on the
operation seat to control machine.
【
Important
】
If there has fault in monitor, shut down the engine at once and check the reason.
Adjust engine rev
Engine rev can be adjusted by accelerograph knob which is in the left operation box of cab,When
accelerograph knob lifted to upmost, engine runs at full load; lower knob to bottommost, engine runs at
minimum load; adjust accelerograph between upmost and bottommost to adjust engine rev, and also you can
screw handle to adjust accelerograph imperceptibly.
Stop engine
【
Important
】
Don’t stop engine directly when it is full loaded, it should stop engine after 5 minutes
minimum loaded operation to unload the heat load and avoid possible damage to engine. If engine stop with
load, it should remove load and start engine at once.Before with loading, please run 1 minute with half of the
speed.
a) Place machine to the flat ground.
b) Lower the bucket to ground.
c) Place the accelerograph knob to minimum load position and run engine for about 5 minutes to make engine
cool down.
d) Rotate key switch to ‘OFF’position and close engine, then take out the key..
e) Place pilot control lever to LOCK positio
Use assistant battery
【
Important
】
Earth the 12V cathode (-), and only use
12V assistant battery.
When the battery exhaust, you can start engine with assistant
battery.

Connect assistant battery(As figure 3.3.13)
Figure 3.3.13
Figure 3.3.12