SUNWARD SWE18UF, Руководство по эксплуатации и техническому обслуживанию

Страница: 84 / 120

OPERATION & MAINTENANCE MANUAL SWE18UF
78
should be as little as possible. Use adjusting gasket to adjust the middle clearance.(use the
same amount of gasket at both sides)
8) Grease pin A and B.
Lubrication of control lever
Add some lubricant to the control lever and pedal if
they cannot move smoothly.
A. Control lever
1) Disassemble the low part of the rubber
dustproof cover of the operation lever, turn
over it upward.
2) Clean the aging lubricant and add new
lubricant.
3) Reposit the rubber dustproof of control lever.
B. Control mechanism
1) Remove rubber mat
①
.
2) Loosen the bolt, disassemble cover
①
.
3) Disassemble rubber dustproof
②
.
4) Use doper to add lubricant to lubricant nozzle
③
.
5) Clean the overflowed lubricant.
6) Fit the cover and rubber mat in the reversed order of disassembly operation.
Check track sag
…every 50 hours (or when necessary)
Park the excavator with engine off,
takes out the key, set pilot safety
control lever to lock position. If
not, the sudden movement of excavator
may cause serous damage.

engine is just stopped, touching these
parts may cause serous scald.

If it is needed to maintain the
machine while engine is running, the
cooperated work of 2 men is
necessary, one should sit on the
operator’s seat while another one do
maintenance work.

Keep your body and clothes away
from the transmission parts.

When the engine is running , it is
very dangerous to stand behind the
machine, as the machine is likely to
move suddenly.

Do not move the radiator box cover
or the water venting plug before the
engine coolant has cooled down.
Shut off engine, slowly loosen the
radiator box cover and water
venting plug after the engine and
radiator cover have cooled down.
Never start engine when the
hydraulic oil tank is empty.