SUNWARD SWE18UF, Руководство по эксплуатации и техническому обслуживанию

Страница: 40 / 120

OPERATION & MAINTENANCE MANUAL SWE18UF
34
FIG. 3-15
3.4.3 Travel Speed
When the machine is traveling, press high/low speed switch
⑥
on control panel( FIG 2-5), the
shift of travel motor high and low speed is achieved, then the machine can travel at high or low
speed.
3.4.4 Travel Brake
Release travel pedal or travel handle, it will return to neutral position automatically, the machine
stops traveling.
3.4.5 Key Points of Travelling
1) Avoid crossing over obstacles whenever possible. Because the machine may get injured
from the possible strike. If you must do so, keep the bucket attachment close to the ground
and stride over the obstacle slowly with the centre of the track.
2) On uneven ground, travel at low speed and avoid accelerating, stopping or changing
directions abruptly.
3) When working in water, check the depth of the water, make sure that the water’s depth is
not higher than the half of the track roller. Never dip the rear end of the machine into water.

If the lubricant parts need to work in water for a long time, add enough lubricant oil until
the old oil is replaced.

Never imerge the slew bearing in water or sand,
if you have to do so, contact the dealer or
technician to confirm if this is allowed.
4) Pay special attention to the balance when traveling
on a slope (the maximum grade ability is 20°,
maximum lateral tipping angle is 10°). And you
should note that when actual working area
conditions are poor, the machine’s stability might be lower. FIG. 3-14

When traveling on slopes or grades, lower the bucket to a height of 20 to 30cm. In
emergencies, lower the bucket to the ground and stop the machine.

When traveling on slopes or grades, move slowly in first gear (low speed).

Do not travel down slopes in reverse.

Do not change the directions or cross
slopes sideways. First return to a flat
surface, then redirect the machine.