SUNWARD SWE18UF, Руководство по эксплуатации и техническому обслуживанию

Страница: 83 / 120

OPERATION & MAINTENANCE MANUAL SWE18UF
77

Fit the lock pin into the hole completely as instructions.
 Check the bucket teeth at regular interval to ensure the abrasion, don’t exceed the scheduled
limitation.
Replace bucket
1) Park machine on the level ground, lower the bucket to the ground and place its plane surface
on the ground. Ensure the bucket won’t roll after pins are removed.
2) Remove the orientation pin at the clip spring exterior and take out orientation pin.
3) Remove bucket pin A and B, separate arm and
bucket.
4) Clean orientation pin, pin and holes, daub
sufficient lubricant to them.
5) Calibrate the arm and new bucket, ensure the
bucket will not to roll.
6) Fit pin A and B, and fit corresponding
orientation pins and new clip springs.
7) Adjust bucket connection clearance of pin A
and B. Guarantee the unilateral clearances between bucket and connection rod, and between
clearance bucket and arm are from 0.25mm to 0.7mm, the clearance between pin and bucket
Correct
Wrong
To prevent injury caused by flying off
metal scrap when beat the connection
rod in or out, wear goggles, safety
glasses or other safety instrument.
FIG.100
FIG.98
Never start engine when the
hydraulic oil tank is empty.