37
4.
Attach the temperature probe connector to part B as follows: with the black surface
facing downward, hold the probe connector end against the notches on the probe
holder, as shown in red (step 1 shown below).
5.
Rotate the connector upwards until it snaps securely into place (step2 shown above).
The black surface faces outward and the cord extends upward.
6.
Slide part B onto part A as shown (this connects the temperature
probe connector to the temperature unit connector), and insert the
temperature probe into the well.
7.
Turn the device on using the power button on the
right side of the BP module. At the end of the start-
up sequence, the temperature module display will
blank except for the appropriate temperature unit
icon (
°
F or
°
C). A short beep indicates that the
Sun
Tech 247
is ready.
Note: If the temperature module does not appear to be working properly, cycle the power
several times using the power button on the right side of the BP module. This will
―synchronize‖ all the modules. The modules are synchronized when, after you turn the
power on, all segments on all module displays light simultaneously for 3 to 5 seconds,
followed by a short beep, and all displays go to their ―ready‖ state (BP: battery icon and
middle segments of the systolic value are lit; Temperature: appropriate temperature units
icon is lit; Pulse Oximetry: the ―%SpO2‖ icon is lit).
Temperature unit
connector (not
shown)
B
A
