SUNSTONE Orion 150s Series, Руководство пользователя

Страница: 6 / 48

2
• Questions? Call or Text +1-801-658-0015
Orion
™
150 s Users Guide
MOUNTING OPTIONS
Mounting Option 1 - Clamp to Table
This option is best for tables with accessible edges and
for mounting without drilling holes in the table.
Note: If your table is thicker than 3-1/2” (9cm), follow
the instructions for mounting options 2 or 3 on the next
page.
Hardware required from Box 2:
(1) Angled Bracket (C)
(1) Sunstone Microscope Arm Assembly (A)
(1) Clamp Mechanism (D)
(5) Flat Head Hex Screws (G)
• Lay the arm assembly down on the tabletop.
• As shown in Figure 2.1, attach the angled
bracket (C) to the bottom of the arm using three
(3) of the included flat head hex screws (G)
using a 4mm (5/16”) Allen wrench (L).
• Attach the clamp mechanism (D) to the angled
bracket using two (2) of the included flat head
hex screws (G). See Figure 2.2. For thicker
tables, attach the clamp mechanism D to the
two lower holes in the angled bracket C.
• Adjust the knob on the clamp mechanism (D)
until the gap is sufficient for the thickness of
your tabletop.
• Lock the arm into place by turning the knob
on the clamp mechanism until the clamp is
pressing firmly against the bottom of the table.
• Lift the Arm Assembly up and slide the arm
onto the table as shown in Figure 2.3.
• A plastic cable guide cover (E) can be clipped
on over the angled bracket if desired. See
Figure 2.4
Mounting Option 2 - Bolt through Table
Mounting Option 2 is best for tables without accessible
edges. Hardware required from Box 2:
Figure 2.1. Attach angled
bracket C to A
Figure 2.2. Attach clamp
mechanism D to angled
bracket C.
Figure 2.4. Cover the clamp
mechanism D with the
plastic cable guide cover E.
Figure 2.3. Lift Arm Assembly
up and slide onto the table.