SUNSTONE Orion 150s Series, Руководство пользователя

Страница: 9 / 48

Questions? Call or Text +1-801-658-0015 •
5
The Micro Welder Experts
Stylus Shaft (A) Collet (B) Collet Cap (C) Electrode (D) Stylus Hull (E)
place.
• Rotate the stylus holder to approximately a
45-degree angle as shown in Figure 4.3 (the
stylus should be angled down).
• Fine tune the position of the Welding Stylus
while looking through the microscope: Loosen
the thumb screw on the bottom side of the
stylus holder and slide the Welding Stylus
forward and backward until the tip of the
Welding Stylus is in the center of your focus.
See the example in Figure 5.2.
• Now securely tighten the Welding Stylus in
place by tightening the thumb screw on the
bottom of the stylus holder, which you can see
in Figure 4.3.
Electrode Setup
The Orion i Series pulse arc welder comes standard
with a 1.0mm electrode collet and ten (10) 1.0mm
electrodes. The 1.0mm electrodes are a good multipur-
pose electrode for most welding applications. Available
separately, Sunstone offers 0.5mm electrodes, which
are more suited for very small applications (less than 5
Ws of energy).
HOW TO PLACE THE ELECTRODE INTO THE
WELDING STYLUS
See the Stylus Components Chart (Figure 5.4) to install
the tungsten electrode (D) and then carefully follow
these instructions:
Figure 5.2. Tubing and other cables can be routed up and
through the removable cable guide portion of the arm.
Figure 5.1. Mount the Welding Stylus to the holder below
the microscope.
Figure 5.3. When
looking through the
microscope, the stylus
should appear in the
center of your focus,
as shown here.
Stylus Components
Figure 5.4