50
6.10.1 Ethernet Communication
step 1
((O
Op
pttiio
on
na
all)) Strip the insulation layer of the communication cable with an Ethernet wire
stripper, and lead the corresponding signal cables out. Insert the stripped communica-
tion cable into the RJ45 plug in the correct order, and crimp it with a crimper.
1: RJ45 plug
2：Protective cap
Skip this step if a standard network cable with RJ45 plug is prepared.
step 2
Unscrew the swivel nut from the communication module and take out the inner sealing
ring.
step 3
Unscrew the housing from the communication module.
step 4
Thread the network cable through the swivel nut and gasket. Afterwards, route the cable
into the opening of the sealing. Finally, insert the cable through the housing.
User Manual
