Sunbeam 20060328, Руководство по обслуживанию

Страница: 5 / 64

INSTALLATION
•
Recommend to place the refrigerator out of the reach of direct sunlight or electric home appliances causing heat, such as a
stove or a dishwasher. In hot conditions or environments, the refrigerator will work less efficiently.
•
Connect it to a plug with the voltage indicated in the series plate placed in the back of the refrigerator. Don’t install other
machines in this same plug in order to avoid voltage fluctuations.
•
Try to prevent the use of an extension cord in this connection. If not possible, use an extension cord with the same
characteristics of the refrigerator’s feed cable.
•
To facilitate the air flow around the refrigerator, recommend to leave at least 75mm space over the cabinet and a minimum
25mm space at each side. Separate the refrigerator 30mm from the wall.
•
The refrigerator is equipped with rollers to facilitate moving. Only move it forwards or backwards. Swinging the refrigerator
may cause the wheels breakage.
•
Swing the leveling screws until the refrigerator is slightly inclined backwards. This position helps doors self-closing and avoids
self-opening.
•
If the refrigerator is equipped with an Ice Maker Automatic Unit, a water supply valve must be placed near the refrigerator.
•
REMEMBER: the temperature inside the refrigerator is affected by the door gaskets closure, the frost accumulation in the
evaporator, the service load, the room temperature, the percentage of relative humidity, the thermostats calibration (connection
and disconnection), fan blades position in the motor axis and the compressor’s efficiency.
Temperature control
The refrigerator’s starting time and the internal temperature will be affected by the doors frequent opening and the location room
temperature. Recommend the temperature control adjustment as the refrigerator is designed to work between 10ºC and 40ºC
room temperature.
•
The temperature control has been manufactured to work under normal operating conditions.
•
When a refrigerator is connected for the first time it must work empty for 2 to 3 hours before loading it with food.
•
Recommend temperature control adjustment in accordance with this chart:
POSITION OF
CONTROL
TYPE OF
WEATHER
ROOM
TEMPERATURE
1 to 3 Cold 10 to 20° C
3 to 5 Mild 20 to 30° C
5 to 7 Warm 30 to 40° C
•
If, for some reason, the refrigerator was laying down for transportation, it must be connected after six hours, as the
compressor’s oil must drain to the motor.
•
If the refrigerator has to be laid down again, the compressor’s suction line should remain upwards.
•
The condenser shouldn’t be used for cloth drying. It must be kept completely free and clean.
PAGE . A3