Sun Oracle Sun Blade T6340, Руководство по установке и администрированию

Страница: 42 / 82

32 Sun Blade T6340 Server Module Installation and Administration Guide • April 2010
▼
To Power on the Server Module Manually
●
You can also use a pointed object or stylus to press and release the recessed
Power button on the server front panel.
When main power is applied to the full server, the Power/OK LED above the Power
button lights and remains lit.
▼
To Shut Down Main Power Mode
To power off the server from main power mode, use one of the following two methods:
■
Graceful shutdown. Use a pointed object or other stylus to press and release the
Power button on the front panel. This causes Advanced Configuration and Power
Interface (ACPI) enabled operating systems to perform an orderly shutdown of
the operating system. Servers not running ACPI-enabled operating systems will
shut down to standby power mode immediately.
■
Emergency shutdown. Press and hold the Power button for four seconds to force
main power off and enter standby power mode.
When main power is off, the Power/OK LED on the front panel will begin flashing,
indicating that the server is in standby power mode.
Note –
To power off the server completely, you must either remove the server
module from the chassis or disconnect the AC power cords from the back panel of
the chassis.
Installing the Solaris Operating System
on a Hard Drive
The basic configuration of the Sun Blade T6340 server module ships with or without
hard drives. If you ordered an optional hard drive with preinstalled software, refer
to
“Preinstalled Software” on page 5 .
If you ordered an optional hard drive without preinstalled software and want to
install the Solaris OS on the hard drive in slot 0, you must install the operating
system from your network.
For instructions on how to install the operating system from the network, refer to the
Solaris Installation Guide: Network-Based Installations . You can obtain this guide at: