Sun Microsystems Ultra 1 140, Руководство по обслуживанию

Страница: 137 / 176

System Board and Component Replacement 10-15
10
10.3.2 Replacing an SBus Card
1. Place the SBus card on an antistatic surface.
2. If required, set the jumpers or switches on the card.
See your SBus product documentation.
3. Remove the SBus card extractor (if any).
a. Bend one leg of the extractor slightly to the outside until the hook
clears the hole in the SBus card.
See Figure 10-13.
b. Remove the other side of the extractor.
It should come out easily without being bent.
Figure 10-13 Removing the SBus Card Extractor
4. Slide the card at an angle into the system unit by hooking the card
backplate under the two tabs on the back panel.
See Figure 10-14. Be sure the card backplate shows through the slot on the
back panel.
SBus card extractor
SBus card