Sun Microsystems StorEdge L1000, Руководство пользователя

Страница: 52 / 128

30 Sun StorEdge L1000 User’s Guide • May 1998
▼
To Place Tape Cartridges in Load and Bulk
Packs
Note – The load and bulk packs should already have been removed as a result of
the previous procedure. For more information, see “To Place Tape Cartridges in
Fixed Storage Bins” on page 28.
1. Load eight cartridges in each pack.
As you slide each cartridge into a bin, there should be initial resistance from the
retention mechanism before the cartridge snaps into place. If a cartridge does not
snap into place, check for correct orientation and structural integrity.
2. Make sure each cartridge is properly oriented and seated in the bin. See
FIGURE 2-14
for correct cartridge orientation.
Caution –
Handle the load and bulk packs with care. Although a retention
mechanism secures the cartridges, this mechanism can be compromised by rough
handling, causing the cartridges to fall out.
3. Reinstall the load and bulk packs.
a. Insert a pack into the library, cartridge-edge first.
b. Line up the pack with the plastic guides on the top and
bottom of the library frame.
c. Slide the pack onto the guides until it snaps into place.
d. Repeat Steps 3a–3c for the other pack.
4. Close and lock the library doors.
a. Close the right door and then the left.
b. Insert the key into the lock on the left door and turn the key clockwise to the
locked position.
c. Remove the key and put it in a safe place.