Sun Microsystems StorEdge L1000, Руководство пользователя

Страница: 45 / 128

Chapter 2 Installing the Library 23
2. Adjust the position of the tray.
a. Remove the cosmetic panel from the tray.
b. Loosen the eight inner adjustment screws on the sides of the tray (
FIGURE 2-8
).
The rear inner adjustment screws are not accessible unless the tray is detached
from the slide rails. To adjust the tray, these screws must be loosened before
installing the tray onto the rails.
c. Install the tray onto the slide rails as explained on page 21.
d. Push the tray and the locking brackets all the way into the rack.
e. Adjust the locking brackets so they are in contact with the front mounting
brackets.
f. Adjust the tray so that the front of the tray is 0.25 inch (6 mm) recessed from
the front of the locking brackets.
g. Tighten the four front inner adjustment screws (two on each side of the tray).
To do this, gently pull the tray out of the rack without altering the amount of
recess between the tray and the locking brackets, and then tighten the screws.
h. Remove the tray from the slide rails.
i. Tighten the four rear inner adjustment screws on the tray.
j. Install the tray onto the rails.
k. Install the cosmetic panel onto the tray.