Sun Microsystems StorageTek T10000, Руководство оператора

Страница: 64 / 120

View/Change Configuration Settings
62 T10000 Operator’s Guide • July 2008 Revision EA • 96174
Port A/B Hard Physical Address Submenu
PA=xx,ddd
Defaults to last saved selection.
xx
(hex) is the Arbitrated Loop Physical
Address (AL_PA). ddd is the decimal
index into the ALPA table.
Appears only with
Hard PA Y
As you manually change the decimal index
digits (valid indexes are
125-000 ), the PA
hex display automatically changes (see
TABLE 4-2 on page 69 ).
1. Do one of the following:
■
Press
Menu
to bypass
■
Press Select to start the
change mode:
2. Press Select to increment digit until
desired value appears, then press
Menu
to
set.
3. Repeat step 1 for each digit.
4. Press
Menu to advance to the next
submenu; or, press
Select
to restart the
change mode.
Port A/B Soft Physical Addressing Submenu
Soft PA HI
Soft PA LO
Defaults to last saved selection.
The drive seeks a soft PA in an ascending
order at loop initialization.
The drive seeks a soft PA in a descending
order at loop initialization.
Appears only with
Hard PA N
Do one of the following:
■
Press Menu to bypass
■
Press Select to toggle; then, press
Menu to set, and advance to the next
submenu.
Note: Manufacturing ships drives with
Soft PA LO
option selected.
The Solaris default FCP-driver behavior requires Soft PA LO .
Interface Speed Rate Submenu
Rate Auto
Rate 4Gb
Rate 2Gb
Rate 1Gb
Selects interface speed rate.
Speed determined by network.
Speed rate fixed at 4 Gb
Speed rate fixed at 2 Gb
Speed rate fixed at 1 Gb
Note : When fixed speed rate is selected, the
drive only operates at the selected rate. If
the network is fixed at a different rate, the
drive does not log on.
Do one of the following:
■
Press Menu to bypass
■
Press Select until desired option
appears; then, press Menu to set, and
advance to the next submenu.
Note : Manufacturing ships drives with the Rate Auto option selected.
T10000A drives operating in AS400 environments with code level 1.37.114 should support 4Gb transfer
rates. If the user encounters problems when writing highly compressible data, the service representative
should refer to Field Action Bulletin (FAB) 200869.
Port A/B Maximum Data Frame Size Submenu
MaxSz 2112
MaxSz 2048
Selects maximum frame size.
Do one of the following:
■
Press
Menu
to bypass
■
Press Select to toggle; then, press
Menu
to set, and advance to the next
submenu.
Note : Manufacturing ships drives with the MaxSz 2112 option selected.
TABLE 4-1
Drive Configuration Settings (Continued)
Options Notes Procedure