Sun Microsystems StorageTek T10000, Руководство оператора

Страница: 41 / 120

96174 • Revision EA 39
C H A P T E R
3.
Operator Tasks
This chapter discusses operator tasks primarily for rack-mounted T10000 tape drives.
For operator tasks relating to drives within a library, consult library operator guides.
Power-on Rack Mount Drives
To apply power to the rack mount tray:
1. Make sure the rack mount tray is connected to an AC power outlet or power strip.
2. Make sure that all interface cables are fully seated.
3. Set the rear panel power switch to on ( | ).
(see
FIGURE 2-3 on page 37
)
Both drives power-on and start performing an initial program load (IPL).
Note – The power indicator flashes while the IPL is in progress.
(left most operator panel LED, see
FIGURE 2-2 on page 34
.
The operator panel display window displays various messages relative to the IPL
sequence. These messages do not require operator action.
The drive successfully completes an IPL when:
■
The drive power indicator is steady.
■
The operator panel display window displays an asterisk (*).
Power-off Rack Mount Drives
To remove power from the rack mount tray:
1. Make sure there is not a job or application running on the host that is using this tape
drive. If there is, stop that job or application.
2. Make sure a cartridge is not loaded in the tape drive.
3. Set the rack mount tray rear panel power switch to off ( O ).
(see
FIGURE 2-3 on page 37
)