Sun Microsystems 5500, Справочное руководство

Страница: 181 / 304

Chapter 12 Preparing for Service 12-9
12.3.8 Stabilizer Bar
The cabinet has six levelling pads. Four pads on the cabinet frame are lowered to
touch the floor and prevent the cabinet from rocking. Two levelling pads are part of
the stabilizer bar and should not touch the floor.
1. Extend the stabilizer bar fully from the bottom of the cabinet (
FIGURE 12-6
).
FIGURE 12-6
Stabilizer Bar and Levelling Pads
2. Screw the two stabilizer bar levelling pads down until they are 1
/
8
- to 1
/
4
-inch (3 to
6 mm) above the floor.
Ensure both pads are at equal heights above the floor. This clearance allows the
stabilizer bar to slide in and out easily, yet catch the cabinet if it should begin to tilt.
Caution – Always extend the stabilizer bar before pulling the disk drive trays out
for servicing.
Leveller
pad
Stabilizer bar