SummaSign Pro T-series Cutters
User’ s Manual
Operation
2-25
To repeat the test, press the
key.
Press the
key to repeat the calibration procedure or press the
key to
interrupt the routine.
However, if you obtained a pattern as illustrated above, increase the value
displayed on the LCD by pressing the
jogging key to correct closing of the
lines cut.
To repeat the test, press the
key.
Press the
key to repeat the calibration procedure or press the
key to
interrupt the routine.
A complementary test has been added to fine tune the LONG. adjustment.
Press the
1
key to perform the horizontal test; all the squares should be
identical.
2.5.2. CUT BORDER
The CUT BORDER submenu is used to cut the border of the media area which
was defined during the load sequence. This function is particularly useful if you
want to verify the exact cutting area.
2.5.3. MENU PLOT
The MENU PLOT is a hard copy of the present cutter configuration, i.e. the items
selected in the USER CONFIG submenus described in Section 2.3. The plot is
organised by menu categories to show the current values for the various USER
CONFIG 1(->4) configurations. To run this plot, load a sheet of plotting paper
and install a pen.
