Sullair 1107e, Руководство оператора и списки запасных частей, Страница: 45 / 102

6.7 SEPARATOR MAINTENANCE
Replace the separator element when indicated by the WS
Controller or after one (1) year, whichever comes first. The
separator element must be replaced. DO NOT attempt to
clean the separator element.
Separator Element Replacement
Refer to Figure 6-3. The separator should be changed
once a year. Follow the procedure explained below for
element replacement:
WARNING
Before performing compressor
maintenance, disconnect the
compressor from the power source
and lock out the power source. Isolate
the compressor from the line
pressure by closing the
recommended discharge shut-off
valve and releasing all internal
pressure from the compressor.
1. Insert a 100mm maximum length, 6mm diameter pin
into the radial-drilled hole in the separator cap. Loosen
and rotate counterclockwise to remove the cap.
2. Pull out the old element by gripping the end of the
element with channel lock pliers or a similar tool.
3. Remove the separator element.
4. Once the separator is removed, the separator fluid
return line can be accessed for removal and cleaning.
5. Install the new O-rings on the separator cap and
separator element filter. Oil lightly to make installation
easier.
6. Insert and push the new element into place.
7. Reinstall the cap. Hand-tighten using a 100mm
maximum length, 6mm diameter pin in the radial-
drilled hole.
SU_0000093
1
2
3
4
1. O-ring*
2. Separator Element
3. O-ring*
4. Cap
Separator Element: 02250160-776
*Separator Replacement Kit: 02250160-774
Figure 6-3: Separator Element Assembly
MAINTENANCE
®
SULLAIR
®
1100e, 1500e, 1800e Operator’s Manual and Parts List
41