Subaru 2015 XV Crosstrek, Руководство пользователя

Страница: 481 / 572

inserted until it stops.
1) Full level
2) Low level
3) Approximately 1.1 US qt (1.0 liter, 0.9
Imp qt) from low level to full level
4. Pull out the oil level gauge again.
5. Check the oil levels on both sides of
the level gauge. The engine oil level must
be judged by the lowest of the two levels.
If the oil level is below the low level mark,
add oil so that the full level is reached.
CAUTION
.
Be careful not to touch the en-
gine oil filter when removing the
oil filler cap. Doing so may result
in a burn, a pinched finger, or
may cause some other injury.
.
Use only engine oil with the
recommended grade and vis-
cosity.
.
Be careful not to spill engine oil
when adding it. If oil touches the
exhaust pipe, it may cause a bad
smell, smoke, and/or a fire. If
engine oil gets on the exhaust
pipe, be sure to wipe it off.
.
If the level gauge is not pulled out
easily, twist the level gauge right
and left, then pull it out. Other-
wise, you may be injured acci-
dentally straining yourself.
To add engine oil, remove the engine oil
filler cap and slowly pour engine oil
through the filler neck. After pouring oil
into the engine, you must use the level
gauge to confirm that the oil level is
correct.
NOTE
To prevent overfilling the engine oil, do
not add any additional oil above the
upper level when the engine is cold.
&
Changing the oil and oil filter
CAUTION
If you change your own oil, be sure
to drain all the oil from the filter
before disposal. Do not dispose of
used engine oil by placing it in the
trash, or by pouring it onto the
ground, into sewers, or into any
body of water. Check with your local
government office for the proper
disposal options available to you.
Change the oil and oil filter according to
the maintenance schedule in the
“
War-
ranty and Maintenance Booklet
”
.
The engine oil and oil filter must be
changed more frequently than listed in
the maintenance schedule when driving
on dusty roads, when short trips are
frequently made, or when driving in
extremely cold weather.
1. Warm up the engine by letting the
engine idle for approximately 10 minutes
to ease draining the engine oil.
2. Park the vehicle on a level surface and
turn the ignition switch to the
“
LOCK
”
(off)
position.
3. Remove the oil filler cap.
Maintenance and service/Engine oil
11-11
–
CONTINUED
–