Stryker Power-PRO TL Cot, Руководство по эксплуатации

Страница: 8 / 798

• Do not attempt to load the cot into the vehicle patient compartment with the head section retracted. Loading the cot with
the head section retracted may cause the product to tip or not connect to the vehicle cot fastener.
• Do not install or apply a wheel lock on a product with worn wheels that are less than 6 in. diameter.
• Do not leave a patient or occupant unattended. Hold the product while a patient or occupant is on the product.
• Always use all restraint straps to secure the patient on the cot. An unrestrained patient may fall from the cot.
• Do not attach restraint straps to the base tubes or cross tubes.
• Always locate the buckle away from obstructions or accessories on the cot to avoid the risk of accidental release of
P Pe ed dii--M Ma atte e® infant restraint system and injury to the infant.
• Always lock the optional push bar into its mount to prevent the push bar from coming out during use.
• Do not lift the product with the optional push bars.
• Always store the push bars in the base storage pouch when not in use.
• Do not remove the battery when the cot is activated.
• Do not attempt to open the battery pack for any reason, to avoid the risk of electric shock. If the battery pack case is
cracked or damaged, do not insert it into the charger. Return damaged battery packs to a service center for recycling.
• Always avoid direct contact with a wet battery or battery enclosures. Contact may cause injury to the patient or operator.
• Do not insert a cracked or damaged S SM MR RT T Pak into the S SM MR RT T charger. Return damaged S SM MR RT T Paks to a service
center for recycling.
• Always have a certified mechanic, familiar with ambulance vehicle construction, install the optional mounting bracket
and the S SM MR RT T charger.
• Always mount the S SM MR RT T charger to the optional mounting bracket in an enclosed cabinet and out of patient reach
during transport to comply with established crash test standards.
• Always make sure that the optional mounting bracket is securely attached to the surface.
• Always use any appropriate personal protective equipment while power washing to avoid inhaling contagion. Power
washing equipment may aerate contamination.
• Always wipe the product with clean water and dry after cleaning. Some cleaning products are corrosive in nature and
may cause damage to the product. Failure to properly rinse and dry the product leaves a corrosive residue on the
surface of the product and may cause premature corrosion of critical components.
• Always wear insulated rubber gloves, in addition to personal protective equipment, when cleaning the S SM MR RT T Pak to
reduce the risk of injury.
• Always disconnect the S SM MR RT T charger from the wall outlet before cleaning to avoid the risk of electrical hazards.
• Do not spray fluid directly onto the S SM MR RT T charger.
• Do not power wash the S SM MR RT T charger.
• Do not use solvents, lubricants, or other chemicals to clean the S SM MR RT T charger unless otherwise directed.
• Do not immerse the S SM MR RT T charger in water or allow water to collect on top of the S SM MR RT T charger to avoid the risk of
electric shock.
• Always use only non-conductive materials to wipe the S SM MR RT T Pak.
• Always avoid excessive water exposure to the S SM MR RT T Pak terminals.
• Always refer to the disinfectant’s Material Safety Data Sheet (MSDS) to verify the pH range. Disinfectants with pH levels
higher than 10.5 may cause the S SM MR RT T Pak housing material to crack.
• Do not directly handle or make contact with the S SM MR RT T Pak terminals while cleaning to avoid the risk of injury.
• Do not immerse the S SM MR RT T Pak in liquid to reduce the risk of electric shock.
• Do not use solvents, lubricants, or other chemicals to clean the S SM MR RT T Pak unless otherwise directed.
• Always relieve pressure before you disconnect hydraulic or other lines. Escaping fluid under pressure can penetrate the
skin and cause serious injury. Tighten all connections before you apply pressure. If an accident occurs, see a doctor
immediately.
• Do not use bare hands to check for hydraulic leaks.
C CA AU UT TIIO ON N
• Improper usage of the product can cause injury to the patient or operator. Operate the product only as described in this
manual.
• Do not modify the product or any components of the product. Modifying the product can cause unpredictable operation
resulting in injury to patient or operator. Modifying the product also voids its warranty.
• Always charge the battery before you place the product into service. An uncharged or depleted battery may cause poor
product performance.
EN 4 6550-309-005 Rev H.0