Stryker Power-PRO TL Cot, Руководство по эксплуатации

Страница: 21 / 798

B
A
A
6506/6516 6550
F Fiig gu urre e 6 6 –– C Ch he ecckkiin ng g tth he e h ho ou urr m me ette err ((A A)),, e errrro orr d diissp plla ayy ((A A)),, a an nd d b ba atttte erryy sstta attu uss ((B B))
O Op pe erra attiin ng g g gu uiid de elliin ne ess
W WA AR RN NIIN NG G
• Always operate the cot only when all persons are clear of the mechanisms. Entanglement in powered cot mechanisms
can cause serious injury.
• Always inspect S SM MR RT T Paks for damage before every use.
• Do not allow untrained assistants to assist in the operation of the product.
• Always follow proper hand placement on hand grips. Keep all hands clear of the red safety bar pivots when you load or
unload the cot or change cot height position.
• Do not ride on the base of the cot.
• Do not transport the cot sideways to avoid the risk of tipping. Always transport the cot in a lowered position, head end or
foot end first to minimize the risk of tipping.
• Always keep hands, fingers, and feet away from moving parts. Use caution when placing your hands and feet near the
base tubes while you raise or lower the cot.
• Always install the in-fastener shut-off system in any emergency vehicle that will be used with this cot if using an antler
style cot fastener.
• Always conduct patient monitoring when the cot is idle. If you hydraulically raise or lower the product you may
temporarily affect electronic patient monitoring equipment.
C CA AU UT TIIO ON N -- Always clear any obstacles that may interfere and cause injury to the operator or patient before operating the
product.
• Operate the product only as described in this manual.
• Read all labels and instructions on the product before use.
• Practice changing height positions and loading the cot until you fully understand the operation of the product.
• Inspect the S SM MR RT T Pak housing and terminal area for any cracks or damage before first and every use.
• Always load or unload an occupied cot with a minimum of two trained operators. Two operators must be present when a
cot is occupied. Stryker recommends that both operators are at the foot end to reduce the load on each operator. One or
two operators can lift from the foot end of the cot.
• Do not adjust, roll, or load the cot into a vehicle without advising the patient. Stay with the patient and control the product
at all times.
• You can transport the cot in any position. Stryker recommends that the operators transport the patient in the lowest
comfortable position to maneuver the cot.
• Only use the wheel locks during patient transfer or without a patient on the product.
6550-309-005 Rev H.0 17 EN