Striper Seaswirl Series, Руководство пользователя

Страница: 101 / 148

Pumping Fuel
IMPORTANT: Follow engine manufacturer’s recommendations for
types of fuel and oil. Use of improper products can damage the engine
and void the warranty.
1. Be sure to fuel in a well-lit area. It’s hard to see gasoline spills if
lighting is poor or in the dark.
2. Remove the gas fill cover.
A Comment from Seaswirl: Check the label on the plate before pump-
ing fuel. Don’t confuse the waste pumpout or fresh water cover with the
gas fill cover. Disposal of gasoline from a holding tank is difficult.
3. Insert the fuel supply nozzle, keeping it in contact with the fuel fill
plate to guard against static-produced sparks.
4. Stand away from the fuel tank vent and gas fill during fueling. Fuel
may splash back, irritate eyes and/or create a fire hazard.
5. Avoid spilling gasoline. It can harm the environment. Wipe up any
excess fuel immediately.
6. After pumping approximately 10 gallons of fuel into the fuel tank,
inspect the engine and fuel tank area for any signs of leakage. If no
leaks or other problems are detected, resume fueling.
7. Allow space at the top of the tank for thermal expansion.
A Comment from Seaswirl: You may not be able to fill the tank to
100% of its dry-rated capacity. The boat’s floating attitude, which affects
the position of the fuel tank and its vent, may limit the amount of fuel
the tank will hold. If fuel flows out the tank vent, stop fueling immedi-
ately. The tank is as full as possible under current conditions.
8. If fuel cannot be pumped in at a reasonable rate, check for fuel vent
blockage or a kink in the line.
9.3
Fire and Explosion Hazard! Do not smoke. Extinguish all open
flames. Stop engines. Do not use electrical switches and other
devices that could cause a spark or flame, including the bilge blow-
er. Close all openings into cabin area.
55095-Seaswirl-09_GetUnderway 9/8/05 3:16 PM Page 9.3