STRATOS FU-230, Инструкция по эксплуатации

Страница: 34 / 46

©
Drechselbedarf Schulte - 34 - Translation of the Original Instruction Manual Version 1.0
In order to use the outrigger (Fig. 66 and 67), attach the lathe bed extension (B) (only available as an
option) to the designated anchor points (A) on the stand using
the supplied mounting kit (G, Fig. 6). Loosen the clamping lever
(K, Fig. 65) to be able to pull or push the headstock.
In order to rotate the headstock, unlock the locking device (D)
(Fig. 65).
To do this,
loosen the
headstock
pivot locking
pin (D)
counter-
clockwise,
then pull on it.
Now the entire
headstock can
be rotated by
Fig. 66
90°and 180°
in the required
direction. Afterwards, lock the headstock using the
Fig. 67
clamping lever (K) and the headstock pivot locking pin (D). Now insert the tool rest support (U) into the
bed extension. In order to compensate for the greater outrigger spindle height, insert the shaft extension
(V) into the stand and the tool rest as usual into the shaft extension, and lock both in position.
Danger!
Warning: Crushing hazard!
•
Please keep your fingers on the side of the locking device.
•
Watch out for your fingers when moving the headstock. They must not be
underneath the locking device, because of crushing between locking device and
lathe bed.
right wrong
Notes for woodturning
For larger diameters, the headstock must be moved closer to the centre of the lathe bed so the
tool rest can be pushed to the outside of the work piece.
S
K
D
V
A U
B