STRATOS FU-230, Инструкция по эксплуатации

Страница: 23 / 46

©
Drechselbedarf Schulte
-
Translation of the Original Instruction Manual Version 1.0 - 23
7. Connecting the wood turning lathe to the mains supply
The operator must use an isolated socket fused with 16 amp. The mains voltage and rating must
correspond to the data on the lathe's rating plate.
The building must be equipped with mains protection which is connected to the lathe's safety plug.
The supplied safety plug must be used with a suitable isolated socket which has been appropriately
installed, according to country-specific electrical regulations.
Danger!
•
A lathe which has been connected and does not comply with regulations can lead to
an electric shock.
•
All connections and repairs to the electrical equipment must be carried out by a
qualified electrician.
8. Commissioning
To begin with, check that the machine has been set up and assembled correctly.
Before commissioning, remove all loose parts and tools that may be lying on the lathe.
Turn the main switch to "0". On the movable control unit, turn the toggle switch to "forward" and turn the
potentiometer all the way to the left, to zero.
Insert the safety plug into the designated isolated socket.
Now switch the main switch to "I". (Switch it back to "0" when you have finished working with the lathe.)
To start the machine, press the green button (I) on the movable control unit.
By turning the potentiometer, you are increasing the speed to the required rpm.
.
When starting the lathe with a work piece inserted, ensure the potentiometer is on "0". Then press
the green
ON button to turn on the speed.
9. Using the wood turning lathe
Headstock
The headstock consists of the power unit (electric motor) with
quick-release lever and clamping lever to loosen the belt,
pulleys with gear ratio, spindle with M33 x 3.5 mm thread and
additional 34 mm flange as well as a No. 2 Morse taper (MT2),
knob for spindle lock (clicks into place at 90° rotation), knob for
24-position indexing (clicks into place at 90° rotation), cover for
pulleys with viewing window, clamping lever for cover,
handwheel, clamping lever for moving the headstock, digital
display of the spindle speed in rpm, and headstock pivot
locking pin.
Fig. 41