STRATOS FU-230, Инструкция по эксплуатации

Страница: 29 / 46

©
Drechselbedarf Schulte
-
Translation of the Original Instruction Manual Version 1.0 - 29
V
Replacing the belt
If you ever need to replace a faulty belt, this is very easy
with the Stratos lathe. Disconnect the mains plug and
only then open the cover (A). Loosen the quick-release
lever (S) on the motor and, using the chromium-plated
clamping lever, pull the motor toward the headstock. This
loosens the tension in the Poly-V belt. Secure the
position with the quick-release lever.
Now remove the faulty belt (cut with a knife or scissors if
required). The new belt is put over the handwheel,
guided past the spindle shaft and belt cover and then
placed on the pulleys. Afterwards, using the chromium-
plated clamping lever, push the motor in the opposite
Fig. 57 Open cover
direction which retentions the belt. Secure this position using the quick-release lever (S) and close the
cover and toggle latch (V, see Fig. 64). Now you can connect the mains plug again. The belt drive is now
ready.
Fig. 58
Fig. 60
Fig. 59
Fig. 61
Fig. 62
Fig. 63 Lock
Fig. 64 Closed cover
Motor lever
S
A