STRATOS FU-230, Инструкция по эксплуатации

Страница: 11 / 46

©
Drechselbedarf Schulte
-
Translation of the Original Instruction Manual Version 1.0 - 11
6. Installation site requirements
Requirement Recommendation
Lathe installation site
Position the Stratos 230 close to a power source (isolated socket).
Ensure the floor is level, solid and stable.
Leave sufficient space around the machine. Also consider sufficient
space for when the headstock has been rotated, for the bed extension
and/or the outrigger. Other machines in the workshop must not interfere
with the lathe's operation.
Lighting and ventilation
Ensure adequate lighting (
lighting intensity according to DIN 5035
) and
ventilation. Also use adjustable lighting for your working area at the lathe
so no shadow is cast on the work piece. We recommend a light source
with a value of at least 300 LUX, or even better, 500 LUX at the cutting
edge of the tool.
If possible, position the machine close to a window.
Electrical equipment
To operate the wood turning lathe, a suitable, conventional 230 V
isolated socket fused with a 16-amp supply is required.
Electric cables and sockets must comply with local electricity regulations.
If in doubt, ask your electrical specialist. Avoid the use of an extension
cable (see Chapter "Connecting the wood turning lathe to the mains
supply").
Ventilation
Adequately ventilate your workplace. The degree of ventilation depends
on the size of the workshop and the number of work pieces being
processed. The use of dust extractors and filters reduces health hazards.
Working height
Set up the working height of the wood turning lathe, so the spindle
centre is at the same level as the user's elbow.
Working area
When securing the lathe to the floor, free space around the lathe of at
least 80 cm is required for repairs and maintenance work.
Stand
If the lathe is used without a stand, the operator must choose a suitable
installation surface. In this case, the outrigger cannot be used.