Stoneridge SE5000, Руководство по управлению

Страница: 30 / 34

Display Messages
Display Description Action
No
further details
Fault
An unknown type of sensor error occurred.
Related to the motion sensor. Replace the motion sensor.
Over
speeding
Warning
The vehicle speed has exceeded the speed
limit set for 1 minute and will be stored.
Related to the operator. Find out the maximum speed allowed
for the vehicle.
Overspeeding
pre-warning
Message
The vehicle is exceeding the over speed limit
set.
After 1 (one) minute of continuous over
speeding the warning will be stored. Related
to the operator.
Driver related message. Observe the
specified speed limit
Pairing
complete
Message
The motion sensor - tachograph pairing proc-
ess has been completed successfully. [Work-
shop card]. Related to the tachograph or
motion senor. No further action required.
Pairing
failed
Message
The motion sensor - tachograph pairing proc-
ess has failed. [Workshop card]. Related to
the tachograph or motion sensor. Remove the workshop card from the
tachograph.
Check the system connections.
Re-insert the workshop card to retry
pairing.
Replace the sensor if required.
If the message is shown repeatedly the
tachograph might be faulty beyond
repair and must be decommissioned
and replaced.
PIN?
Message
Enter a PIN code to:
l
Activate a tachograph
l
Enter the tachograph calibration mode
[Workshop card]. Related to the tachograph.
Enter a valid PIN code.
Power supply
interruption
Warning
The power supply to the tachograph has
been interrupted for more than 200 mil-
liseconds. Cranking voltage should not cause
this event. The event is not generated in cal-
ibration mode. Related to the vehicle. Check the vehicle and tachograph
power supply levels.
Check the power supply cables.
Check the vehicle´s battery and replace
if necessary.
Printer high
temperature
Message
The printing could not start, or the ongoing
printing has been interrupted, because the
temperature of the printer is too high.
Related to the printer. Wait until the printer temperature is in
allowable range and try to print again.
Printer
low power
Message
The ongoing printing has been interrupted
because the tachograph input voltage is too
low. Related to the vehicle. Check that the ignition is on.
Check the vehicle battery voltage, con-
nections, etc.
Printer
low temperature
Message
The printing could not start because the tem- Wait until the printer temperature is in
allowable range and try to print again.
- 28 -