22
866-795-1586 • WWW.STONEAGETOOLS.COM
Contact StoneAge for Safety Data Sheets for material usage, a complete list of spare part numbers, and service instructions for
the
AUTOBOX
®
ABX-PRO-100
and CB-ABX-PRO-100-X Control Box.
MAINTENANCE AND TROUBLESHOOTING
STORAGE, TRANSPORTATION, AND HANDLING
When storing the unit, use compressed air to blow out the air lines to remove debris and moisture. Use mild soapy water to clean the
machine in order to remove corrosive materials.
Maintenance Item
Frequency
Maintenance Required
Air Motors
After
each use
Apply a small amount of air tool oil directly into the forward and reverse
fittings. Then, briefly operate the controls at slow speed for a short duration
in each direction to coat the interior parts of the motor.
All Air Fittings
After
each use
Reinstall all dust caps to protect from dirt and moisture.
All components the hoses pass
through
After
each use
As wear occurs the rounded edges could become sharp and damage
hoses. Any components showing excessive wear should be replaced.
Roller grooves
Before
each use
Replace roller if cuts or roughness is present. (See the Roller Removal and
Installation pages in this manual )
Hose
After
each use
Install cap on threads to protect threads and prevent contamination.
Lubricator of control box
Before
each use
Add oil when fluid drops below minimum level marking.
Snout and BOP Components
After
each use
Wash out any material build up to prevent components from being clogged.
Waterblast Tool
After
each use
Remove tool, lubricate and store in clean container.
Webbing strap
Before
each use
Replace strap when frayed, cut or torn
Problem
Solution
No air is delivered to tool
-Check that shut-off valve near regulator is open
-Check that regulator is set to 100 psi
-Open flow control valves by rotating the brass colored speed controls in the
counterclockwise direction.
Hose is being damaged by Rollers
-Check that the proper Rollers are installed (see roller and collet reference plate)
-Loosen eccentric lever to reduce clamp force on hose.
-Check Rollers for excessive wear in groove
Hose slippage on Rollers
-Check that the proper Rollers are installed (see roller and collet reference plate)
-Tighten eccentric lever to retain clamp force on hose.
MAINTENANCE
TROUBLESHOOTING