11
866-795-1586 • WWW.STONEAGETOOLS.COM
QUARTER PLATE FLANGE MOUNT (BOP 010-2-4 QTR) TO PIPE AND ABX-PRO
1. Attach the Quarter Plate Flange Mount to the pipe flange using the fasteners that were removed from the flange joint. The nuts shown
between the pipe flange and the Quarter Plate Flange Mount are to allow for drainage. Other spacer options such as washers are
acceptable.
(Figure 1)
2. Adjust the Quarter Plate Flange Mount by sliding it along the slots to center the inside diameter of the Hinge Clamp with the inside
diameter of the pipe. Tighten all hardware to secure in place.
(Figure 2)
FIGURE 1
FIGURE 2
FIGURE 3
USE FASTENERS
REMOVED FROM THE
FLANGE JOINT
ALIGN INSIDE
DIAMETERS
Pipe shown
for graphic
representation only.
Not included in
assembly.
QUARTER PLATE FLANGE MOUNT ASSEMBLY SET-UP
BOP 030 COLLET
BLOCK ASSEMBLY
BOP 081-6
SNOUT TUBE
COLLET CAP
BLOCKS
GUIDE
TUBE
AUTOBOX
®
ABX-PRO
TRACTOR
3. Loosen the screws on both collet cap blocks. Slide the BOP 030 Collet Block Assembly onto the guide tube on the ABX-PRO and
tighten the two screws until secure. Slide the BOP 081-6 Snout Tube into the BOP 030 Collet Block Assembly. Push the Snout Tube in
until it stops, then tighten the two until secure.
(Figure 3)