Page 48
Due to continuous product research and development,
the information contained herein is subject to change without notice.
www.stoddart.com.au
www.stoddart.co.nz
Cleaning and Maintenance
Cleaning external surfaces
1. The oven exterior should never be cleaned with direct water or high pressure jets
2. Wipe clean using a cloth dampened with clean warm soapy water until all has been removed
3. Scrub any baked on soil with the cleaner pad in the same direction as grained polished finish.
Do not scrub the display panel
4. Wipe clean using a cloth dampened with clean warm water until all Stainless Cleaner and soil has been removed
5. Using a clean sanitised cloth, thoroughly wipe the stainless steel and metal parts dry. Do NOT let water pool on the unit. Check crevices
and folds
Normally, the automatic wash cycles clean internal racks effectively.
However if required, these can be easily removed.
1. Loosen the rack mount screw
2. Lift the rack upward
3. Pull the rack sideways then remove from the oven cavity
4. Clean using warm soapy water, rinse thoroughly and dry
5. Re-install into the oven, ensure the rack locking levers are
pushed back into position
Cleaning Internal Rack
3
Control panel ventilation filter
Moisture Drain
In order to keep the electronic components of the oven at a safety temperature, the ventilation
filter should be cleaned periodically, at least once a month.
The filter is located on the rear side of the oven “A”.
Proceed as follows:
Holding the filter tab “C”, slide the filter upward to remove. Wash using with warm soapy water,
dry with a clean cloth.
Moisture drain “B” ejects the vapours produced inside the oven chamber.
Check that it is clean and free from obstructions.
IMPORTANT
If the oven enters Hi Temp alarm state, the most
probable cause is an excessive dirt accumulation
on the filter. Clean the filter immediately
Cleaning Glass Door
The door glass can be cleaned both on the outside and on the inside.
1. Rotate the two latches that lock the internal glass door
2. Swing internal glass door open
3. Clean with warm soapy water and a clean cloth
Never use abrasive materials
4. Close the glass door, rotate the two latches back into position
