Page 29
Due to continuous product research and development,
the information contained herein is subject to change without notice.
www.stoddart.com.au
www.stoddart.co.nz
Operation
To set the Delta T:
A. Connect the core probe to the combi oven
B. Select Core probe then press the Delta T icon
C. Touch the value fields to set the core probe temperature and chamber temperature (set the chamber tempaerature between 15°C -
30°C higher than the core probe)
D. Turn the navigation dial to adjust the temperature value
E. Press the navigation dial to save the set value
Delta T(Δt):
• Delta T(Δt):
During the cooking cycle, the oven increases or decreases the cooking chamber’s temperature automatically to keep the Delta T
(Δt) value constant (e.g. 30°C). These cooking cycles are perfect for cooking meat slowly and at low temperatures to keep it soft
and tender without losing excessive weight.
Delta T (Δt) = Temperature in the chamber - (minus) Probe core temperature
The Delta T(Δt) function is used mainly for slow, low temperature cooking.
In Delta T(Δt) mode, the product core temperature is set and the chamber temperature is set between 15°C - 30°C higher. As the core
temperature rises, the temperature in the chamber will increase maintaining the set difference.
Note:
A probe must be used for the Delta T(Δt) function.
SET
PUSH
E
D
Friday, 01 April 2020
16:20
O
I
START
Pre-heat
Manual
PHASE 1
120°
57’
Friday, 01 April 2020
16:20
O
I
START
Pre-heat
Manual
PHASE 1
30°
10°
B
C
Note:
When not in use, place the probe back into the magnetic support.
At the end of the cooking cycle, take care to remove the probe from the core before taking the tray out of the oven. The core probe is very
sharp and it reaches high temperatures after cooking, do not pull the probe by the connection wire to remove it.
Do not insert the hot probe in frozen food to prevent thermal shock to the probe, which can cause the probe to become damaged.
A
