Stober 56690, Руководство пользователя

Страница: 125 / 219

STOBER 11 | Communication
05/2019 | ID 442790.01
125
11 Communication
The following options are available for communicating with the SC6 drive controller:
§
Communication between drive controller and controller
• Fieldbus
• Terminals
§
Communication between drive controller and PC for commissioning, optimization and diagnostics
• Direct connection
• Fieldbus
The DriveControlSuite project configuration and commissioning software installed on the PC is able to handle multiple
direct connections simultaneously.
11.1 Direct connection
A direct connection is a network connection in which all nodes are in the same network.
In its simplest form, a direct connection is a point-to-point cable connection between the network interface of the PC
where DriveControlSuite is installed and the network interface of the drive controller. Switches or routers can also be used
in place of a simple network cable.
The IP address required for direct connection is either assigned automatically by DriveControlSuite or using DHCP, or it is
specified manually.
Requirements for a direct connection
§ The socket of the gateway device and the network connection of the PC must have IP addresses from the same subnet
§ The A166 parameter of DriveControlSuite must be set to 2: DHCP + DS6 for the direct connection to be established
automatically
Also observe the notes in the chapter Communication requirements [
}
200] .
Virtual machines
If you would like to connect STOBER drive controllers to DriveControlSuite from a virtual machine, observe the information
in the chapter
Configuring virtual machines [ } 201] .
11.2 Fieldbus
Detailed information about the fieldbus connection can be found in the corresponding manual, see the chapter Detailed
information [ } 202] .