► Fit the support with the longer banjo bolt on
the adjusting lever (3) – screw in the banjo bolt
and tighten with the combination wrench
► Insert the water hose into the guide in the
V‑belt guard (arrow) from the shut-off cock
towards the guard – avoid tight radiuses
8.1.9
Checking the adjustment range of the
guard
370BA076 KN
A
► Rotate the guard forwards and backwards as
far as possible – adjustment range (A) must be
limited by the stop pin
Continue as described in the chapter “Tensioning
the V‑belt”.
8.2
Inboard mounting
► Disassemble the cutting wheel (see “Fitting /
replacing an cutting wheel”)
► Remove water attachment
► Remove the adjusting lever
► Slacken the V-belt
► Remove the V-belt guard
► Remove the "cast arm with guard"
8.2.1
Preparing the "cast arm with guard" for
inboard mounting
1 2
370BA080 KN
► Unscrew the screw (1) of the limit stop (2)
► Remove the limit stop (2)
3
370BA081 KN
1 2
► Turn the "cast arm with guard" so that the
guard is on the inboard side
► Insert limit stop (2) – align the hole in the limit
stop with the hole in the cast arm
► Screw in the bolt (1) and tighten up
► Unscrew stop pin (3)
3
370BA082 KN
► Turn the guard so that it is in the position
shown (see picture)
► Screw in and tighten the stop pin (3)
► Install the adjusting lever
► Mount "cast arm with guard" – guard on the
inboard side
► Install the V-belt guard
► Connect water connection
English
8 Assembling the cast arm and guard
20
0458-370-8321-C
Содержание TS 410
