Stihl TS 410, Инструкция по эксплуатации

Страница: 16 / 40

Defects
Cause Remedy
abrasive wheel for asphalt with a
new one
poor cutting performance, high
segment wear
Abrasive wheel is turning in the
wrong direction
Mount abrasive wheel so that it
turns in the right direction
Breakdowns or tears in the
parent wheel and segment
Overloading use a new abrasive wheel
Undercut Cutting in the wrong material use new abrasive wheel;
observe separating layers of
various materials
7 Electronic Water Control
STIHL cut-off machines may be equipped with
an electronic water control system.
The electronic water control makes it possible to
feed the optimum amount of water to the abra‐
sive wheel. No water is fed to the abrasive wheel
during idling.
7.1 Before starting work
► Familiarize yourself with the sequence of
motions while the engine is switched off
1307BA001 KN
► All of the control panel buttons can be oper‐
ated with the thumb of the right hand – the
right hand always remains on the rear handle
while doing so
► The left hand always remains on the handle‐
bar
7.2 Control panel
When the engine is running, it is possible to acti‐
vate / deactivate the electronic water control and
adjust the water flow.
2
1
370BA085 KN
3
1 Button (+):
activate the electronic water control or
increase water flow to abrasive wheel
2 Button (–):
activate the electronic water control or
decrease water flow to abrasive wheel
3 Deactivate electronic water control; no water
is fed to the abrasive wheel
7.3 Using the electronic water con‐
trol
► Start engine, see "Starting / Stopping the
Engine"
► Tap on the (+) button or (–) button with the
thumb of the right hand – the right hand
always remains on the rear handle while doing
so, the left hand always remains on the han‐
dlebar – no water is fed to the abrasive wheel
yet during idling
During use, the set amount of water is fed to the
abrasive wheel.
► Adjust water flow if necessary – to do so, tap
on the (+) button or (–) button with the thumb
of the right hand until the correct water quan‐
tity is attained – the right hand always remains
on the rear handle while doing so, the left
hand always remains on the handlebar
If the cut-off machine is idling after use, no more
water will be fed to the abrasive wheel – the elec‐
1)
STIHL recommends STIHL servicing dealers
English 7 Electronic Water Control
16 0458-370-8321-C