► Turn the guard so that it is in the position
shown (see picture)
► Screw in and tighten the stop pin (1)
► Move the adjusting lever (2) to position A
► Screw in the bolt (3) and tighten up
► Unscrew the bolt (4) of the limit stop (5)
► Remove the limit stop (5)
4 5
370BA075 KN
6
► Turn the "cast arm with guard" so that the
guard is on the outboard side
► Insert limit stop (5) – align the hole in the limit
stop with the hole in the cast arm
► Screw in the bolt (4) and tighten up
► Insert the square nut into the guide in the
guard and hold it in place
► Screw in the shorter banjo bolt (6) and washer
at the adjusting lever and tighten up with the
combination wrench
8.1.7
Mount "cast arm with guard" – guard
on the outboard side
1
1
2
2
370BA008 KN
1
2
4
3
► Press the oblong holes (1) in the "cast arm
with guard" on to the studs (2), guiding the rib‐
bed V‑belt over the front pulley
NOTICE
The belt action must run smoothly.
► The belt tensioner (3) must sit close to the
lug (4)
6
6
2
2
2
370BA051 KN
6
5
► Fit the "starter cover with rewind starter" (5)
over the studs (2)
► Tighten up the nuts (6) by hand
8
370BA077 KN
7
► Push the V‑belt guard (7) into place
► Screw in the bolt (8) and tighten up
8.1.8
Connect water connection
1
1
370BA078 KN
2
3
► Insert the longer banjo bolt (1) through the
connector (2) of the water attachment –
observe the position of the connector
► Insert the square nut into the guide in the
guard and hold it in place
8 Assembling the cast arm and guard
English
0458-370-8321-C
19
Содержание TS 410
