55
07/13424999918
GB
WPS
®
2 Window Protection System
Description of parameters
Drive parameters
Time of reversing:
This parameter is used to adjust the travel time for reversing the drive if a sensor is triggered (is OPEN). At the end of the
reversing time, the drive will be stopped until sensor triggering stops and any applicable time delay has ended. If the time
delay has been set to 0, the drive will be stopped when a sensor is triggered and there will be no reversing.
Pole change time:
This time controls the interval that the polarity reversal relay for the motor voltage requires before switching.( 500 ms)
Stop before reversing:
This time controls the interval that the stop relay for the motor voltage requires before switching.( 500 ms).
Feed-in from motor group:
If the WPS2 system is supplied with power via the motor input, this parameter must be set.
In this context, the jumper for power supply via the motor circuit (Feed-in frommotor group) is to be set to position
M
(see section on Power supply for WPS2).
If there is a separate supply, the parameter is to be deactivated and the jumper for power supply via the motor circuit
(Feed-in frommotor group) is to be set to position
N
.
