Wing Cont.
☐
Cut leading edge from 3/8 in. square balsa
stock. Trim so that ends align with the center
of ribs R3 when leading edge is centered.
☐
Install leading edge to forward tips of ribs.
Center leading edge, and square wing on a
flat surface. Bond with medium CA.
☐
Cut paper tubes to 12 in. lengths. Slide tubes
through holes in aft portion of ribs R1, R2,
and R3.
☐
Center tubes so that they extend slightly
beyond ribs R1 and R3.
DO NOT BOND.
☐
Square wing on a flat surface and glue W4’s
to leading edge and notch in rib R1a.
Bond
all mating surfaces between spars, cap strips,
ribs, leading & trailing edges with medium CA.
☐
Assemble center sheeting S1 from parts S1a
and S1b. Bond with thin CA.
SkyBoy 600 © 2010 Stevens AeroModel all rights reserved.
Page 36 of 55
Leading Edge
Leading Edge
Center
of Rib
Paper Tube
W4
Leading Edge
R1a
S1a
S1b
R1/R3
Extend
Содержание SkyBoy 600
