8
9
fAUcET InSTALLATIOn
TUBULAR
1000
B /
1000
e
fAUcET InSTALLATIOn
TUBULAR
1000
B BOX /
1000
e BOX
STEP 1 – InSTALLInG ThE fAUcET
1
Shut off the water supply.
2
Cut an adequate opening in the wall
for the dimensions of the Tubular
box,corrugated tube, rigid pipes
and the Tubular base.
Then, insert the Tubular box through
the wall.
3
Connect the water supply pipes to the
nipples at the bottom of the Tubular
box.
HOT
COLD
4
Prepare the support bar for the
Tubular base by assembling the angle
supports with the 4 provided screws.
Then, mount the Tubular base through
the wall opening using the 2 screws
and anchors provided.
Now, assemble the temporary
protective cover to the faucet base.
IMPORTANT: The Tubular base should be installed so that the outside surface of the
finished wall falls between the minimum and maximum lines marked on the temporary
protective cover.
STEP 3 – cOnnEcTInG ThE POwER SOURcE
1a
For Tubular 1000 B: Connect the
cable coming from the electronic
unit in the Tubular base leading to
the power source, to the battery
box.
FROM THE ELECTRONIC UNIT
TO THE POWER SUPPLY
1b
For Tubular E: Connect the cable
coming from the electronic unit
in the Tubular base leading to the
power source, to the transformer.
Plug the transformer into the
electricity socket.
2
After you have connected the pow-
er source (battery or transformer)
wait about 10 seconds in order to
allow the system to set the ideal
sensor range. Then the product will
be ready for use.
10
SECONDS
ABOUT
3
Turn on the central water supply.
Check for leaks.
NOTE: Tubular includes a special aerator that allows you to
adjust the water stream direction on site in order to prevent
water splashing if needed. To change the angle of the water
stream, simply move the adjustable tilting plate by pressing it
smoothly.
If the automatically adjusted sensor range is not satisfactory to your purposes, please
refer to the section entitled “Settings adjustment”.
