4
5
PRE-InSTALLATIOn InfO
fAUcET InSTALLATIOn
TUBULAR
1000
B /
1000
e
CHeCk COnTenTS
Separate all parts from the packaging and check each part with the pack contents
section. Pay attention to the variations of the different models.
Make sure all parts are accounted for before discarding any packaging material.
If any parts are missing, do not attempt to install your electronic faucet until you
obtain the missing parts.
PRePARATiOn fOR inSTALLATiOn
Flush the water supply lines thoroughly before installing the faucet. Do not allow dirt,
teflon tape or metal particles to enter the faucet. Shut off water supply.
iMPORTAnT
All plumbing is to be installed in accordance with applicable codes and regulations.
STEP 1 – InSTALLInG ThE fAUcET
1
Shut off the water supply.
2
Drill a hole (28 to 29 mm. ) where you
want to install the spout of the faucet,
and a small hole just above the
previous one for the anti-rotation pin.
28-29 mm
3
Remove the gasket, disk and nut from
the base of the faucet and insert the
faucet through the wall.
4
Secure the rosette into position using
the anti rotation pin.
WARNING
1) To avoid reflection problems keep
a distance of more than 300 mm.
between the sink and the spout.
2) This faucet model, with an infrared
sensor pointing down, is not intended
to be used together with a sink of a
reflective material such as stainless
steel.
3) If a sink strainer is straight below
the faucet sensor, use a strainer with
a non reflective finish (do not use a
chrome plated one).
Min 300 mm.
Bottom of the washbasin
